HP MSR Router Series Wan Access Configuration Manual page 234

[RouterA-Bri2/4/0] rip metricin 2
2. Configure Router B:
# Create dialer group 1 and configure a dial rule for it.
<RouterB> system-view
[RouterB] dialer-group 1 rule ip permit
# Create a local user usera for Router A, and configure the service type as PPP.
[RouterB] local-user usera class network
[RouterB-luser-network-usera] password simple usera
[RouterB-luser-network-usera] service-type ppp
[RouterB-luser-network-usera] quit
# Configure an IP address for interface Dialer 0.
[RouterB] interface dialer 0
[RouterB-Dialer0] ip address 20.0.0.2 24
# Enable PPP encapsulation on the interface.
[RouterB-Dialer0] link-protocol ppp
# Configure PAP authentication on the interface.
[RouterB-Dialer0] ppp authentication-mode pap
[RouterB-Dialer0] ppp pap local-user userb password simple userb
# Enable bundle DDR on the interface.
[RouterB-Dialer0] dialer bundle enable
# Specify the host name of the remote router allowed to call in.
[RouterB-Dialer0] dialer peer-name usera
# Associate the interface with dialer group 1.
[RouterB-Dialer0] dialer-group 1
# Configure the dial string for calling Router A.
[RouterB-Dialer0] dialer number 8810010
[RouterB-Dialer0] quit
# Assign interface BRI 2/4/0 to Dialer 0.
[RouterB] interface bri 2/4/0
[RouterB-Bri2/4/0] dialer bundle-member 0
# Configure PAP authentication on the interface.
[RouterB-Bri2/4/0] ppp authentication-mode pap
[RouterB-Bri2/4/0] ppp pap local-user userb password simple userb
[RouterB-Bri2/4/0] quit
# Configure an IP address for interface Serial 2/1/0.
[RouterB] interface serial 2/1/0
[RouterB-Serial2/1/0] ip address 10.0.0.2 8
# Enable PPP encapsulation on the interface.
[RouterB-Serial2/1/0] link-protocol ppp
[RouterB-Serial2/1/0] quit
# Configure an IP address for interface Loopback 1.
[RouterB] interface loopback 1
[RouterB-Loopback1] ip address 30.0.0.1 32
[RouterB-Loopback1] quit
# Configure RIP.
225