Configuring The Polling Feature - HP MSR Router Series Wan Access Configuration Manual

Step
2. Enter interface view.
3. Configure the authenticator to
authenticate the peer by using
MS-CHAP or MS-CHAP-V2.
4. Configure a username for the
MS-CHAP or MS-CHAP-V2
authenticator.
5. Configure local or remote
AAA authentication.
To configure MS-CHAP or MS-CHAP-V2 authentication when no authenticator name is configured:
Step
1. Enter system view.
2. Enter interface view.
3. Configure the
authenticator to
authenticate the peer
by using MS-CHAP or
MS-CHAP-V2.
4. Configure local or
remote AAA
authentication.

Configuring the polling feature

The polling feature checks PPP link state.
On an interface that uses PPP encapsulation, the link layer sends keepalives at keepalive intervals to
detect the availability of the peer. If the interface fails to receive keepalives when the keepalive retry limit
is reached, it tears down the link and reports a link layer down event.
Command
interface interface-type
interface-number
ppp authentication-mode
{ ms-chap | ms-chap-v2 }
[ [ call-in ] domain isp-name ]
ppp chap user username
For local AAA authentication, the
username and password of the
peer must be configured on the
authenticator.
For remote AAA authentication,
the username and password of the
peer must be configured on the
remote AAA server.
For more information about AAA
authentication, see Security
Configuration Guide.
Command
system-view
interface interface-type interface-number
ppp authentication-mode { ms-chap |
ms-chap-v2 } [ [ call-in ] domain
isp-name ]
For local AAA authentication, the
username and password of the peer must
be configured on the authenticator.
For remote AAA authentication, the
username and password of the peer must
be configured on the remote AAA server.
For more information about AAA
authentication, see Security Configuration
Guide.
9
Remarks
N/A
By default, PPP authentication is
disabled.
The username for the authenticator
must be the same on the local and
peer devices.
The username and password of the
peer configured on the
authenticator or remote AAA
server must be the same as those
configured on the peer.
Remarks
N/A
N/A
By default, PPP authentication is
disabled.
The username and password of the
peer configured on the
authenticator or remote AAA server
must be the same as those
configured on the peer.