Configuring Applications Carried By Atm - HP MSR Router Series Wan Access Configuration Manual

Step
4. Configure the service type and
related parameters for the PVC.
5. Configure the transmission
priority for the PVC.

Configuring applications carried by ATM

As shown in
support ATM applications (such as IPoA, IPoEoA, PPPoA, and PPPoEoA).
Table 6 Encapsulation type support for ATM applications
ATM application
IPoA
IPoEoA
PPPoA
PPPoEoA
NOTE:
When aal5snap is used, a PVC or PVC-group can carry two or more protocols at the same time. When
aal5mux is used, a PVC or PVC-group supports only one protocol at a time.
Table 6, although ATM can carry multiple protocols, a specific encapsulation type might not
aal5snap
Supported
Supported
Supported
Supported
Command
•
Set the service type to CBR and
configure related parameters:
service cbr output-pcr [ cdvt
cdvt-value ]
•
Set the service type to UBR and
configure related parameters:
service ubr output-pcr
•
Set the service type to VBR-NRT
and configure related
parameters:
service vbr-nrt output-pcr
output-scr output-mbs
•
Set the service type to VBR-RT
and configure related
parameters:
service vbr-rt output-pcr
output-scr output-mbs
transmit-priority value
aal5mux
Supported (InARPoA not
supported)
Supported
Supported
Supported
136
Remarks
The default service type is UBR.
The newly configured service
type overwrites the existing
ones. Different PVCs in a
PVC-group or interface can be
configured with different
service types.
By default, the transmission
priority is:
•
0 for UBR services.
•
5 for VBR-NRT services.
•
8 for VBR-RT services.
When you change the service
type for the PVC, the
transmission priority of the PVC
is restored to the default.
aal5nlpid
Supported (InARPoA not
supported)
Not supported
Not supported
Not supported