Setting The Maximum Number Of Pppoe Sessions - HP MSR Router Series Wan Access Configuration Manual

Step
6. Enter Layer 3 Ethernet
interface/subinterface, Layer
3 virtual Ethernet
interface/subinterface, Layer
3 aggregate
interface/subinterface,
VE-L3VPN
interface/subinterface, or
EFM interface/subinterface
view.
7. Enable the PPPoE server on
the interface and bind this
interface to the specified VT
interface.
8. (Optional.) Configure an
access controller (AC) name
for the PPPoE server.
9. (Optional.) Enable the PPPoE
server to support the
ppp-max-payload tag and
specify a range for the PPP
maximum payload.
10. Configure a service name for
the PPPoE server.
11. (Optional.) Set the response
delay time for user access.
12. Return to system view.
13. Configure the PPPoE server
to perform authentication,
authorization, and
accounting for PPP users.

Setting the maximum number of PPPoE sessions

PPPoE can establish a session when none of the following maximum numbers are reached:
The maximum number of PPPoE sessions for a user on an interface.
•
The maximum number of PPPoE sessions for a VLAN on an interface.
•
The maximum number of PPPoE sessions on an interface.
•
• The maximum number of PPPoE sessions on a card. (Distributed devices.)
The maximum number of PPPoE sessions on an IRF member device. (Centralized devices in IRF
•
mode.)
The maximum number of PPPoE sessions on a device. (Centralized devices in standalone mode.)
•
New maximum number settings apply only to subsequently established PPPoE sessions.
Command
interface interface-type
interface-number
pppoe-server bind virtual-template
number
pppoe-server tag ac-name name
pppoe-server tag ppp-max-payload
[ minimum minvalue maximum
maxvalue ]
pppoe-server tag service-name name
pppoe-server access-delay delay-time
quit
See Security Configuration Guide.
47
Remarks
N/A
By default, the PPPoE server is
disabled on the interface.
By default, the AC name for the
PPPoE server is the device name.
PPPoE clients can choose a
PPPoE server according to the
AC name. The PPPoE client on
HP devices do not support this
feature.
By default, The PPPoE server
does not support the
ppp-max-payload tag.
By default, a PPPoE server does
not have a service name.
By default, no response delay
time is set.
N/A
N/A