Compatibility Information; Atm Configuration Task List - HP MSR Router Series Wan Access Configuration Manual

OAM Alarm Indication Signal/Remote Defect Indication—The PVC goes down when specific
•
number of successive AIS/RDI alarm cells are received. The PVC comes up when no AIS/RDI alarm
cells are received within the specified time.
• OAM Continuity Check—OAM CC requires that one end of the PVC must be configured as the CC
cell source and the other end as the CC cell sink. If the detecting end fails to receive CC cells within
3 seconds, the state of the PVC changes to down. The PVC comes up only after CC cells are
received again.
OAM F5 Loopback—Sends OAM F5 Loopback cells at the specified interval after you enable OAM
•
F5 Loopback transmission and retransmission detection and specify related parameters. If the
sender fails to receive a response cell within the specified interval, it sends an OAM F5 Loopback
cell again. The state of the PVC is updated during the Loopback detection. The PVC comes up when
the specified number of successive OAM F5 Loopback cells are received. The PVC goes down when
the specified number of successive OAM F5 Loopback cells are not received.
OAM F5 end-to-end—Sends OAM F5 end-to-end cells through the specified PVC on the specified
•
ATM interface. If no response is received within the specified period, the link might be disconnected
or congested.

Compatibility information

This feature is supported only on routers installed with the following modules:
ADSL2+.
•
ATM-OC3.
•
G.shdsl.
•
G.shdsl.Bis.
•

ATM configuration task list

Tasks at a glance
(Required.)
(Required.)
(Optional.)
(Required.)
(Required.)
Configuring applications carried by
•
(Optional.)
•
(Required.) Perform one of the following tasks:
Configuring IPoA
Configuring IPoEoA
Configuring PPPoA
Configuring PPPoEoA
(Optional.)
(Optional.)
Configuring an ATM interface
Configuring a PVC
Configuring a PVC-group
Configuring the ATM AAL5 encapsulation type
Configuring the ATM service type
Configuring a VE interface
Configuring VP policing
Re-marking the CLP flag value of ATM cells
ATM:
132
Remarks
N/A
N/A
N/A
N/A
N/A
When you configure IPoEoA or
PPPoEoA, you must configure VE
interfaces.
N/A
N/A