Command And Hardware Compatibility; Configuring The Pppoe Server; Configuring A Pppoe Session - HP MSR Router Series Wan Access Configuration Manual

As shown in
•
carrier router (PPPoE server). The service provider assigns an account to each host for billing and
control. The host must be installed with PPPoE client software.
Figure 11 Network structure 2
PPPoE Client
Host A
PPPoE Client
Host B

Command and hardware compatibility

Commands and descriptions for centralized devices apply to the following routers:
MSR1002-4/1003-8S.
•
MSR2003.
•
• MSR2004-24/2004-48.
MSR3012/3024/3044/3064.
•
Commands and descriptions for distributed devices apply to MSR4060 and MSR4080 routers.

Configuring the PPPoE server

Configuring a PPPoE session

Step
1. Enter system view.
2. Create a VT interface and
enter VT interface view.
3. Set PPP parameters.
4. Enable MRU detection.
5. Return to system view.
Figure 1 1, a PPPoE session is established between each host (PPPoE client) and the
PPPoE Server
Router
Command
system-view
interface virtual-template number
See "Configuring
ppp lcp echo mru verify [ minimum
value ]
quit
Internet
PPP."
46
Remarks
N/A
N/A
If authentication is needed, use
the PPPoE server as the
authenticator.
By default, MRU detection is
disabled.
N/A