Products List; Technical Support; Regulatory Information - HP PS110 Quick Start Manual

HP PS110 Wireless VPN Router Quickstart
6. Confirm the settings, and then click Finish.
The router reboots and the PS110 is operational.
E. Test the wireless connection
For the purposes of this example, the PS110 has its DHCP server enabled (the
default setting) and the cable modem is on and operating normally.
1. Disconnect the wired connection from your computer to the PS110.
2. Enable the wireless network interface of your computer.
3.
Use your computer's wireless network utility to find and connect to the
PS110's wireless network. The SSID name is "HP1" in this example.
6
4. When prompted, enter the wireless security passphrase for the network,
as configured in section D, step 5.
5.
Confirm that you can browse the Internet from your computer.
F. To perform additional configuration
Re-launch the PS110 management interface at https://192.168.1.1 and log in
using the configured username and password.
Note: MicroServer information is available on the Servers menu.

Products list

Model Part numbers
HP PS110 JL066A (WW), JL065A (AM)
WW=Worldwide, AM=The Americas (North, Central, and South America)

Technical support

For worldwide technical support information, see the HP support website at
www.hp.com/networking/support.
For more information see "Contacting HP" in the HP PS110 Wireless VPN
Router Installation Guide.

Regulatory information

FCC Notice
FCC ID:
B94MRLBB1401
This FCC Class B device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful interference, and 2)
this device must accept any interference received, including interference that may cause
undesired operation.
For the full FCC Class B equipment notice and other important safety, environmental, and
regulatory information, see Safety and Compliance Information for Server, Storage,
Power, Networking, and Rack Products, available at www.hp.com/support/Safety-
Compliance-EnterpriseProducts.
For products available in the USA/Canada market, 2.4 GHz operation is limited to
channels 1-11.
When this device is operated in 5.15-5.25 GHz frequency range, it is restricted to indoor
use only.
This device will not permit operation on channels 120-132 for 11a and 11n modes that
overlap the 5600-5650 MHz band.
Products list