Power; Safety Information; Professional Installation Required - HP MSM317 Installation And Configuration Manual

Figure 3 MSM317 Components
1
NEMA-WD6 Version
BS 4662 Version

Power

The access device receives power through the Uplink port (either via the RJ-45 connector or
punch-down block) and can supply PoE power on Port 1. The Ethernet connection to this port must
be a standard 10/100 link delivered over category 5 (or better) structured cabling.
Two PoE power settings are available as follows:
When set to 802.1 1af Class 1 to 2, Port 1 supports an 802.3af Class 1 or Class 2 device
drawing a maximum of 6.49 watts.
For the access device to provide 802.1 1af Class 0 and 3 support, it must be powered by an
802.3at or PoE+ source with an output power greater than 23 watts. For example, the new
HP 2910al-POE+ switch provides up to 30 watts per port.
The Uplink port must be connected to an 802.3af compliant power source.
CAUTION:
over-current situation.
The HP Switch 2610 series features several models with PoE support that can be used in conjunction
with the access device to build a cost-effective wireless networking infrastructure.

Safety information

Take note of the following safety information during installation of the access device:

Professional installation required

WARNING!
in RF installation and knowledgeable in local regulations including building and wiring codes,
safety, channel, power, indoor/outdoor restrictions, and license requirements for the intended
country. It is the responsibility of the end user to ensure that installation and use comply with local
safety and radio regulations.
8 Preparing for installation
2 3
4 5
1: Body
2: Faceplate
3: Trim panel
4: Faceplate
5: Trim panel
The access device will be powered off by the PoE power source if there is an
Prior to installing or using a controller, consult with a professional installer trained