Table of Contents
Advertisement
SKYZER TECHNOLOGIES
4 SET UP
4.1 EFTPOS CONFIGURATION
The EFTPOS Configuration option enables the terminal to be configured to
operate as an EFTPOS terminal and must be done before the terminal can
process transactions.
Step
Terminal Display Comment
1.0
2.0
FUNCTION?
3.0
CONFIG PARAMS?
ENTER OR CLEAR
4.0
TERMINAL ID?
XXXXXXXX
5.0
MERCHANT ID?
XXXXXXXXXXX
6.0
NII?
001
7.0
COMMS MODE?
1-DIAL-UP
2-TCP-IP / DIAL
3-TCP-IP
4-GPRS
5-GPRS / DIAL
6-TCP-IP / GPRS
7-TCP-IP/GPRS/DIAL
INGENICO ICT2XX 2017 PAYMARK SOFTWARE OPERATING GUIDE
Press FUNC
Enter 3824 and press ENTER.
ENTER to configure the parameters or CLEAR to cancel and exit to idle prompt.
This parameter specifies the Terminal ID assigned by Paymark. Key in the 8 digit
terminal ID and press ENTER.
This parameter specifies the Merchant ID assigned by Paymark. Merchant ID will be
automatically configured once terminal ID is keyed in. Press ENTER to confirm the
merchant ID is correct and if not, it can be manually over written.
This parameter specifies the Network International Identifier (by default 001) that
the terminal uses to route messages to Paymark. Press ENTER.
Select the preferred COMMS mode by pressing the corresponding number key. By
default 1-TCP-IP is always selected.
Press 1 for Dial-up configuration followed by ENTER and proceed with the
configuration.
Press 2 for TCP-IP/Dialup as backup configuration followed by ENTER and
proceed with the configuration.
Press 3 for TCP-IP configuration followed by ENTER and proceed with the
configuration.
Press 4 for GPRS configuration followed by ENTER and proceed with the
configuration.
Press 5 for GPRS/Dialup as backup configuration followed by ENTER and
proceed with the configuration.
Press 6 for TCP-IP/GPRS as backup configuration followed by ENTER and
proceed with the configuration.
Press 7 for TCP-IP/GPRS/DIAL as backup configuration followed by ENTER
and proceed with the configuration.
PAGE 28 OF 146
VERSION 1.0
Advertisement
Table of Contents
