Adjusting The Position Of The Adf [Fi-7700/Fi-7700S]; Operational Settings - Fujitsu FI-7600 Operator's Manual

Chapter 1 Scanner Overview

1.6 Adjusting the Position of the ADF [fi-7700/fi-7700S]

This section explains how to adjust the position of the ADF.
The available positions are as follows:
 Position 1 (factory default)
 Position 2 (space-saving type: documents loaded on the right)
 Position 3 (space-saving type: documents loaded on the left)
1
Open the document cover.
For details, refer to "1.5 Opening/Closing the Document Cover [fi-
7700/fi-7700S]" (page 25).
2
Remove the two ADF lock screws and insert them into the
lock screw storage holes.
The ADF is fixed with the ADF lock screws in place. If the ADF lock
screws are removed, the position of the ADF can be adjusted.
ADF Lock Screws
ATTENTION
Before adjusting the position of the ADF, make sure that the ADF
lock screws are placed in the lock screw storage holes.
Contents
Introduction
Scanner
Overview
Lock Screw Storage Holes
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
TOP
Index
26