Operational Procedure - Fujitsu fi-7300NX Operator's Manual

When using the Software Operation Panel, refer to
[Intelligent Multifeed Function] (page

Operational Procedure

1
If [Multifeed detected (Overlap)] (error code: "J2:55") is displayed on the touch screen, either press the
[Eject Document] button to eject the document from the paper path or open the ADF to remove the
document.
For details, refer to
CAUTION
2
If you open the ADF to remove the document, close it.
For details, refer to
CAUTION
ATTENTION
Confirm that the ADF is closed properly. Otherwise, documents may not be fed into the ADF.
3
Load the removed document back in the ADF paper chute (feeder).
4
Respond to a message that is displayed in the touch screen.
The following settings can be configured depending on the operation mode that is set in the
[Intelligent Multifeed Detection] screen.
● For [Manually Bypass]
- [Disable the multifeed detection for the next document]
Select whether to detect overlapped documents for the next scan.
- [Keep Multifeed Images]
Select whether to save the image when overlapped documents are detected.
This may not be displayed depending on the scanner driver settings.
● For [Automatically Bypass (combination of length and position)]
- [Memorize Patterns]
Select whether you set the scanner to memorize the paper overlapping patterns.
- [Keep Multifeed Images]
Select whether to save the image when overlapped documents are detected.
This may not be displayed depending on the scanner driver settings.
● For [Automatically Bypass (length)]
- [Memorize Patterns]
292).
How to Open the ADF (page
When the ADF is open, it might close accidentally. Be careful not to get your fingers
caught.
How to Close the ADF (page
Be careful not to get your fingers caught when closing the ADF.
Setting to Ignore Certain Overlap Patterns
62).
63).
108
Various Ways to Scan