Configuration
Note
Enable the SOAP port and the SNMP port in most cases.
1. Enter the System Administrator Mode (Chapter 1 Entering the System Administrator mode
2. Enable either the LPD port or the Port 9100 port as appropriate. In this example, the LPD
3. If necessary, set the IP Address (Chapter 1 Setting the IP address on page 1-11).
4. Exit the System Administrator Mode (Chapter 1 Exiting the System Administrator mode on
5. After the machine is restarted, print out the Printer Settings List to confirm that the LPD
Configuration on the computer
This section describes the configuration procedure for the computer.
•
Notes
•
•
To print from a Macintosh using TCP/IP (LPD), refer to the manual contained in the CD-ROM
included with this product for the print driver installation procedure.
2-2
Downloaded From ManualsPrinter.com Manuals
on page 1-10.)
port is enabled.
a.
Select System Settings.
b.
Select Connectivity & Network Setup.
c.
Select Port Settings.
d.
Select LPD and then select Change Settings.
e.
Select LPD - Port Status and select Change Settings.
f.
Select Enabled and then select Save.
g.
Select Close repeatedly until the Connectivity & Network Setup screen is displayed
page 1-11).
port is enabled.
Note
Configure the LPD as necessary. Refer to LPD on page 3-10 for the LPD configuration. Also
if using Port 9100, configure as necessary. Refer to Port 9100 on page 3-15 for the Port
9100 configuration.
Install the print Driver.
For information about the usable operating systems, refer to Supported operating systems
on page 1-4.
Refer to the manual contained in the "CentreWare Utilities"
CD-ROM for the print driver installation procedure.
System Administration Guide
Xerox 4112/4127 Copier/Printer