Figure 5-3 Removing And Inserting The Air Filter - Cisco Universal Broadband Router uBR10012 Hardware Installation Manual

Chapter 5 Maintaining the Cisco uBR10012 Router
The product order number for a replacement air filter is UBR10-FAN-FILTER=.
Note
Use the following procedure to replace the air filter:
Remove the front cover (see
Step 1
Slide the air filter out of its slot.
Step 2
Step 3 Discard the old filter.
Figure 5-3
Position the new air filter above the tabs on the inside of the front cover and slide it down into the slot.
Step 4
When fully inserted, it should appear as shown in
OL-18259-09
"Removing the Front Cover" section on page
Removing and Inserting the Air Filter
Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
5-3).
Figure 5-4.
Replacing the Air Filter
5-5