Open Setting - Mitsubishi Electric QJ71E71-100 User Manual

7.1.4

Open Setting

Configure settings to open connections for data communications with connected devices.
Project window
"Ethernet" under "Network Type".
Item
IP Address/Port No. Input
Format
Protocol
Open System
Fixed Buffer
Fixed Buffer Communication
Pairing Open
Existence Confirmation
Host Station Port No.
Destination IP Address
Destination Port No.
*1 1388 to 138A
H
*2 The range of 1
86
[Parameter]
Select the input format for the IP address and port number.
Select the communication protocol for the connected device.
( Page 88, Section 7.2, Page 96, Section 7.3)
Set this item when "TCP" is selected under "Protocol".
( Page 89, Section 7.2.2, Page 90, Section 7.2.3, Page 92, Section 7.2.4)
For communications using a fixed buffer, select whether to use the buffer for
sending or for receiving in a connection to the connected device. When not
performing communications using a fixed buffer, select "Send". (
CHAPTER 12)
Select a communication method for communications using a fixed buffer.
( Page 138, CHAPTER 12)
Configure the pairing open setting for communications using a fixed buffer.
( Page 157, Section 12.7)
Select whether to use the alive check function. (
Set the E71 connection port numbers.
Set the IP address of the connected device.
Set port numbers for connections of connected devices.
cannot be specified. (
H
to 400 is available only for the QJ71E71-100 with the serial number (first five digits) of "15042" or later.
H H
[Network Parameter] [Ethernet/CC IE/MELSECNET]
"Open Setting"
Description
Page 233, Section 14.8)
Page 349, Appendix 2)
Select
Setting range
• DEC
• HEX
• TCP
• UDP
• Active
• Unpassive
• Fullpassive
• MELSOFT
Connection
• Send
• Receive
Page 138,
• Procedure Exist
• No Procedure
• Predefined protocol
• Disable
• Enable
• No Confirm
• Confirm
401 to 1387 ,
H H
138B to FFFE
H
0 to FFFFFFFF
H
*2
1 to FFFF
H H
*1
H
H