Mitsubishi Electric QJ71E71-100 User Manual page 198

(2) Buffer memory areas used
The following buffer memory areas are used for IP filter settings.
Buffer memory name
Communication condition setting
(Ethernet Operation Setting) area
Initial error code
Use of IP filter settings
IP filter function type setting
Start IP address
IP address
setting 1
End IP address
IP address setting 2 to 8
196
Address
Decimal
(Hexadecimal)
Ethernet operation setting upon reinitialization process is set.
Communication data code setting (b1)
• 0 : Binary Code
H
• 1 : ASCII Code
H
TCP existence confirmation setting (b4)
• 0 : Use the Ping
H
• 1 : Use the KeepAlive
H
Send frame setting (b5)
• 0 : Ethernet
H
• 1 : IEEE 802.3
31 (1F )
H
H
Setting of write enable/disable at RUN time (b6)
• 0 : Disable
H
• 1 : Enable
H
Initial timing setting (b8)
• 0 : Do not wait for OPEN (Communications impossible at STOP time)
H
• 1 : Always wait for OPEN (Communications possible at STOP time)
H
Reinitialization specification (b15)
• 0 : Reinitialization process complete (reset by the system)
H
• 1 : Reinitialization process request (set by the user)
H
The processing results of initial process and reinitialization process are
stored.
105 (69 )
H
• 0 : Normal completion
H
• Other than 0
Set when using the IP filter function.
• 0 : Do not use (default)
22272 (5700 )
H
H
• 1 : Use
H
Select whether to allow or deny the access from the IP addresses
specified in IP address setting 1 to 8.
22273 (5701 )
H
• 0 : Allow (default)
H
• 1 : Deny
H
Set the IP address to be allowed or denied.
When specifying the IP addresses by range, set the start IP address of the
range.
22274 to 22275
22274 (5702
(5702 to 5703 )
H H
22275 (5703
• 00000000
• 00000001
Set the end IP address of a range to be allowed or denied.
When not specifying by range, set 00000000
22276 (5704
22276 to 22277
(5704 to 5705 ) 22277 (5705
H H
• 00000000
• 00000001
22278 to 22305
The configuration is the same as IP address setting 1.
(5706 to 5721 )
H H
Description
: Abnormal end (error code)
H
): Third octet, fourth octet
H
): First octet, second octet
H
: No setting (default)
H
to DFFFFFFE (0.0.0.1 to 223.255.255.254)
H H
): Third octet, fourth octet
H
): First octet, second octet
H
: No setting/No range specification (default)
H
to DFFFFFFE (0.0.0.1 to 223.255.255.254)
H H
.
H