Additional printer setup
3
Holding the card by its sides, align the plastic pins (1) on the card with the holes (2) on the controller board.
4
Push the card firmly into place as shown in the illustration.
Warning—Potential Damage: Improper installation of the card may cause damage to the card and the
controller board.
Note: The entire length of the connector on the card must touch and be flushed against the controller
board.
5
Close the controller board access door.
Note: When the printer software and any hardware options are installed, it may be necessary to manually
add the options in the printer driver to make them available for print jobs. For more information, see
"Adding available options in the print driver" on page
Installing a printer hard disk
Note: This task requires a flat‑head screwdriver.
41.
31