Dell S5830DN User Manual page 102

Understanding printer menus
Use
Job Buffering
Off
On
Auto
Mac Binary PS
On
Off
Auto
ENA Address
yyy.yyy.yyy.yyy
ENA Netmask
yyy.yyy.yyy.yyy
ENA Gateway
yyy.yyy.yyy.yyy
Parallel [x] menu
Note: This menu appears only when an optional parallel card is installed.
Use
PCL SmartSwitch
On
Off
To
Temporarily store print jobs in the printer hard disk before printing.
Notes:
•
Off is the factory default setting.
•
On buffers jobs on the printer hard disk.
•
Auto buffers print jobs only if the printer is busy processing data from
another input port.
•
Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is then updated.
Set the printer to process Macintosh binary PostScript print jobs.
Notes:
•
Auto is the factory default setting.
•
On processes raw binary PostScript print jobs.
•
Off filters print jobs using the standard protocol.
Set the network address information for an external print server.
Note: This menu is available only when the printer is attached to an external
print server through the USB port.
Set the netmask information for an external print server.
Note: This menu is available only when the printer is attached to an external
print server through the USB port.
Set the gateway information for an external print server.
Note: This menu is available only when the printer is attached to an external
print server through the USB port.
To
Set the printer to automatically switch to PCL emulation when a print job
received through a serial port requires it, regardless of the default printer
language.
Notes:
•
On is the factory default setting.
•
When set to Off, the printer does not examine incoming data. The printer
uses PostScript emulation if PS SmartSwitch is set to On. It uses the
default printer language specified in the Setup menu if PS SmartSwitch is
set to Off.
102