Adjusting The Vacuum Strength - Canon imagePROGRAF iPF6400SE User Manual

iPF6400SE
7
Examine test pattern C1. Determine the pattern in which banding is least noticeable. Press ▲ or ▼ to se-
lect this pattern number, and then press the OK button.
C2 is displayed on the Control Panel.
8
Examine test pattern C2. Again, determine the pattern in which banding is least noticeable. Press ▲ or ▼
to select this pattern number, and then press the OK button.
The adjustment value is now registered, and adjustment is complete.
If streaks seem least noticeable in two patterns but
•
you cannot decide which one is better, choose an in-
Note
termediate value. For example, choose 17 if you
cannot decide whether pattern 16 or 18 is better.

Adjusting the Vacuum Strength

Adjusting the Vacuum Strength
When printing on heavyweight paper or paper that curls or wrinkles easily, if the Printhead rubs against paper, ad-
justing the level of suction against paper on the Platen may improve results.
• Paper rubbing against or becoming caught on the Printhead may jam or result in printed documents that are
soiled.
Important
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to
select the Paper tab (
• If the Tab Selection screen is not displayed, press the Menu button.
Note
2
Press the OK button.
The Paper Menu is displayed.
3
Press ▲ or ▼ to select Paper Details, and then press the OK button.
4
Press ▲ or ▼ to select the type of paper, and then press the OK button.
When VacuumStrngth is set to Automatic, the setting value
•
selected for the previous print job is displayed (to the right of Au-
Note
tomatic ) once you select the type of paper currently supplied.
However, the value is cleared when the printer is turned off or
the paper is replaced.
5
Press ▲ or ▼ to select VacuumStrngth, and then press the OK button.
6
Press ▲ or ▼ to select the desired setting value, and then press the OK button.
User's Guide
).
Adjusting the Vacuum Strength
527