Email Notification When Printing Is Finished Or Errors Occur; Initializing The Network Settings - Canon imagePROGRAF iPF6400SE User Manual
Large format printer
Hide thumbs
Also See for imagePROGRAF iPF6400SE:
- User manual (684 pages) ,
- Service manual (43 pages) ,
- Troubleshooting manual (191 pages)
Table of Contents
Advertisement
iPF6400SE
Email Notification When Printing is Finished or Errors Occur
Email Notification When Printing is Finished or Errors Occur
The printer can notify you of the printer status by email. Even when you are away from the printer, you can know
when printing is finished or if errors occur. Receive notification via email on your mobile phone or at your computer.
Use the imagePROGRAF Status Monitor (Windows) function to set up email recipients and message timing. Be-
sides being informed of finished print jobs or errors, you can also complete settings for email notification when
service is needed or it's time to replace consumables. For detailed instructions, see "Specifying Printer-Related Infor-
mation."
P.489
➔
•
For details on email notification using imagePROGRAF Status Monitor (in Windows), refer to the imagePROG-
RAF Status Monitor help.
Note
Mail server authentication is only supported with imagePROGRAF Status Monitor.
•
Initializing the Network Settings
Initializing the Network Settings
Use RemoteUI to restore the network settings to the default values as follows.
•
Initializing the network settings will also restore the default value of the printer's IP address. As a result, the Re-
moteUI page cannot be displayed in the web browser after this procedure.
Important
•
For instructions on reconfiguring the IP address, see "Configuring the IP Address on the Printer."
•
For details on RemoteUI, see "Using RemoteUI."
1
Start the web browser and enter the following URL in the Location (or Address ) box to display the Remo-
teUI page.
http://printer IP address or name/
Example: http://xxx.xxx.xxx.xxx/
2
Select Administrator Mode and click Logon.
•
If a password has been set on the printer, enter the password.
Note
3
Click Network in the Device Manager menu at left to display the Network page.
4
Click Reset to Default settings in the lower-right corner of the Network Interface group.
5
After confirming the message, click OK to restore the network settings to the default values.
•
You can also use imagePROGRAF Device Setup Utility or the Control Panel to restore the default network set-
tings.
Note
User's Guide
Email Notification When Printing is Finished or Errors Occur
P.469
➔
P.471
➔
491
Advertisement
Table of Contents
Troubleshooting
