Remove Pulley; Remove Rectifier End Frime - Toyota 1PZ Repair Manual

CH-10
Type A
SST (B)
SST (C)
CHARGING SYSTEM - Alternator
(b) Remove the four rubber insulator.
CH0852
(c) (Type A)
CH0854
4.

REMOVE PULLEY

SST
(a) Hold SST (A) with a torque wrench, and tighten SST
(A)
SST 09820-63010
Torque: 400 kg-cm (29 ft-lb, 39 N-m)
(b) Check that SST (A) is secured to the rotor shaft.
CH0882
(c) As shown in the illustration, mount SST (C) in a vise,
(d) To loosen the pulley nut, turn SST (A) in the direction
NOTICE: To prevent damage to the rotor shaft, do
not loosen the pulley nut more that one-half of a turn.
(e) Remove the alternator from SST (C).
(f) Turn SST (B) and remove SST (A and B).
(g) Remove the pulley nut and pulley.
CH0853 CH0874
5. REMOVE RECTIFIER END FRAME
(a) (PZJ, HZJ and HDJ)
(b)
CH0855
Remove the seal plate.
(B) clockwise to the specified torque.
and install the alternator to SST (C).
shown in the illustration.
Remove the four nuts and condenser.
(HZBandHDB)
Remove the four nuts.