Toyota 1PZ Repair Manual page 212

FUEL SYSTEM - Injection Pump
(q) Check the installation direction of the camplate as
follow:
• (1PZ)
Disconnect the injection pipe from the position
marked "A" on the distributive head.
• (1 HZ and 1HD-T)
Disconnect the injection pipe from the position
marked "C" on the distributive head.
• Using SST, remove the delivery valve holder.
SST 09260-54012 (09269-54020)
• Check that fuel is flowing out when the mark is in
the position shown in the illustration.
If not, it is improperly assembled.
• Disassemble and change the camplate position
180° in the opposite direction.
HINT: At this time, disconnect the fuel cut solenoid wire
harness.
• Using SST, install the delivery valve holder.
SST 09260-5401 2 (09269-54020)
• Connect the injection pipe.
FU-73