Remove Steel Ball; Remove Brush Holder - Toyota 1PZ Repair Manual

ST-16 STARTING SYSTEM - Starter
(b) Remove the following parts from the magnetic switch:
(1) Starter housing and clutch assembly
(2) Return spring
(3) Plate washer
(4) Idler gear
(5) Bearing
3.

REMOVE STEEL BALL

Using a magnetic finger, remove the steel ball from the
clutch shaft hole.
4.

REMOVE BRUSH HOLDER

(a) Remove the two screws and end cover from the field
frame.
(b) Using a screwdriver, hold the spring back and discon-
nect the brush from the brush holder. Disconnect the
four brushes, and remove the brush holder.
5. REMOVE ARMATURE FROM FIELD FRAME