FUEL SYSTEM - Injection Pump
(c) Using a 4 mm hexagon wrench, install two new
gaskets and the two bolts.
24. INSTALL ADJUSTING LEVER SHAFT TO GOVERNOR
SHAFT
Install the following parts to the governor cover:
(1) Plate washer
(2)
(3) Adjusting lever shaft, O-ring and plate washer
25. INSTALL GOVERNOR COVER
(a)
Install the speed control spring to the adjusting shaft.
(b) Install a new gasket to the groove of the governor
cover.
(c) Install the damper spring and spring seat, and connect
the speed control spring to the spring seat.
(d) Using a 5 mm hexagon wrench, install the governor
cover with the four bolts.
Torque: 85 kg-cm (74 in.-lb, 8.3 N m )
HINT:
Use the bolt which is 35 mm (1.38 in.) in length.
(e)
(w/ HACand 1HD-T)
Install the idle speed adjusting screw.
26. INSTALL ADJUSTING LEVER
(a)
Place the return spring on the governor cover.
New O-ring
assembly
FU-61