Assembly Of Piston And Connecting Rod Assemblies; Install Piston Rings - Toyota 1PZ Repair Manual

EM-106
ENGINE MECHANICAL
ASSEMBLY OF PISTON AND CONNECTING
ROD ASSEMBLIES
1. ASSEMBLE PISTON AND CONNECTING ROD
(a) Install a new snap ring on one side of the piston pin
hole.
• Position the snap ring so that end (B) of the snap
(b) Gradually heat the piston to about 80°C (176°F).
(c) Apply a light coat of engine oil to the piston pin.
(d) Align the front marks of the piston and connecting
rod, and push in the piston pin with your thumb.
(e) Install a new snap ring on the other side of the piston
pin hole using the same method as in (a) above.
2.

INSTALL PISTON RINGS

(a) Install the coil by hand.
(b) Using a piston ring expander, install the oil ring.
Cylinder Block
ring is aligned with the hollow, then push the snap
ring into the piston groove starting from end (A).