Adjustment Of Valve Clearance; Set No 1 Cylinder To Tdc/Compression - Toyota 1PZ Repair Manual

ENGINE MECHANICAL - Engine Tune-Up

ADJUSTMENT OF VALVE CLEARANCE

HINT: Adjust the valve clearance while the engine is cold.
1. REMOVE INTAKE PIPE
(See step 6 on page EM-34)
2. REMOVE CYLINDER HEAD COVER
(See step 7 on page EM-35)
3. SET NO.1 CYLINDER TO TDC/COMPRESSION
(a) Turn the crankshaft pulley clockwise, and align its
(b) (1PZ)
(c) (1 HZ and 1HD-T)
If not, turn the crankshaft one revolution (360°) and align
the mark as above.
4. ADJUST VALVE CLEARANCE
(a) Check only those valves indicated in the illustration.
Valve clearance (Cold):
(b) Turn the crankshaft one revolution (360°), and align
(c) Check only the valves indicated in the illustration.
groove with the timing gear cover groove.
Check that the valve lifters on the No.1 cylinder are
loose and exhaust valve lifter on the No.5 cylinder is
tight.
Check that the valve lifters on the No.1 cylinder are
loose and valve lifters on the No.6 cylinder are tight.
• Using a thickness gauge, measure the clearance
between the valve lifter and camshaft.
• Record the valve clearance measurements which
are out of specification. They will be used later to
determine the required replacement adjusting shim.
Intake 0.15-0.25 mm (0.006-0.010 in.)
Exhaust 0.35-0.45 mm (0.014-0.018 in.)
the mark as above (See procedure step 3).
Measure the valve clearance.
(See procedure step (a))
EM-19