Toyota 1PZ Repair Manual page 10

IIM-6
INTRODUCTION General Repair Instructions
(d) When steam cleaning an engine, protect the air filter,
(e) Never use an impact wrench to remove or install temp,
(f)
(g) When using a vacuum gauge, never force the hose
13. After removing and reinstalling the injection pump and fuel
hoses, clean off the fuel on engine components. In partic-
ular, be sure to check the radiator hose and by-pass hose,
because they deteriorate easily if they come into contact
with fuel.
and injection pump from water.
switches or temp, sensors.
When checking continuity at the wire connector,
insert the tester probe carefully to prevent terminals
from bending.
onto a connector that is too large. Use a step-down
adapter instead. Once the hose has been stretched, it
may leak.