Replacement Of Camshaft Oil Seal - Toyota 1PZ Repair Manual

EM-72
ENGINE MECHANICAL

REPLACEMENT OF CAMSHAFT OIL SEAL

HINT: There are two methods (A and B) to replace the oil
seal as follows:
REPLACE CAMSHAFT OIL SEAL
A. If camshaft oil seal retainer is removed from cylinder
head:
(a) Using a screwdriver and hammer, tap out the oil seal.
(b) Using SST and a hammer, tap in a new oil seal until its
surface is flush with the oil seal retainer edge.
SST 09223-46011
(c) Apply MP grease to the oil seal lip.
B. If camshaft oil seal retainer is installed to the cylinder
head:
(a) Using a screwdriver, pry out the oil seal.
NOTICE: Be careful not to damage the camshaft.
Tape the screwdriver tip.
(b) Apply MP grease to a new oil seal lip.
(c) Using SST and a hammer, tap in the oil seal until its
surface is flush with the oil seal retainer edge.
SST 09223-46011
Cylinder Head