Toyota 1PZ Repair Manual page 87

EM-76
1HZ
ENGINE MECHANICAL - Cylinder Head
B. Select new cylinder head gasket
(1PZ)
HINT: There are five types of cylinder head gasket (hole
number 1 to 5) installed at factory, but only three types for
supply parts (hole number " 1 " , "3" and "5"), so when
replacing the gasket select from one of three types above.
New cylinder head gasket thickness:
Hole number " 1 " 1.16-1.24 mm
Hole number "3" 1.26-1.34 mm
Hole number "5" 1.36-1.44 mm
Select the largest piston protrusion value from the measure-
ments made, then select the appropriate cylinder head
gasket according to the table below.
(1HZ and 1HD-T)
HINT: There are five types of cylinder head gasket (cutout
number 1 to 5) installed at factory, but only three types for
supply parts (cutout number " 1 " , "3" and "5"), so when
replacing the gasket select from one of three types above.
New cylinder head gasket thickness:
Cutout number " 1 " 1.15-1.25 mm
Cutout number "3" 1.25-1.35 mm
Cutout number "5" 1.35-1.45 mm
Select the largest piston protrusion value from the measure-
ments made, then select the appropriate cylinder head
gasket according to the table below.
1HD-T
(0.0457-0.0488 in.)
(0.0496-0.0528 in.)
(0.0535-0.0567 in.)
(0.0453-0.0492 in.)
(0.0492-0.0531 in.)
(0.0531 -0.0571 in.)