Adjust Protrusion Of Governor Shaft; Assemble High Altitude Compensator - Toyota 1PZ Repair Manual

FUEL SYSTEM Injection Pump
If the thrust clearance is not as specified, adjust with a
governor gear adjusting washer.
Governor gear adjusting washer thickness:
1.05 mm (0.0413 in.)
1.25 mm (0.0492 in.)
1.45 mm (0.0571 in.)
1.65 mm (0.0650 in.)
1.85 mm (0.0728 in.)

21. ADJUST PROTRUSION OF GOVERNOR SHAFT

(a) Using vernier calipers, measure the protrusion of the
governor shaft.
Protrusion: 0.5-2.0 mm (0.020-0.079 in.)
If the protrusion is not as specified, adjust by turning the
governor shaft.
(b) Install and tighten the nut while holding the governor
shaft with a 5 mm hexagon wrench.
22. (1 PZ (w/ HAC) and 1 HZ (w/ HAC))

ASSEMBLE HIGH ALTITUDE COMPENSATOR

Install control lever
(a) Insert the connecting pin into governor cover.
(b) Using a small screwdriver, install the control lever with
the support pin.
FU-59