Assembly Of Starter; Magnetic Switch; Perform Pull/Hold-In Coil Open Circuit Test; Place Armature Into Field Frame - Toyota 1PZ Repair Manual

ST-22 STARTING SYSTEM - Starter

Magnetic Switch

1. PERFORM PULL-IN COIL OPEN CIRCUIT TEST
Using an ohmmeter, check that there is continuity between
terminals 50 and C.
If there is no continuity, replace the magnetic switch.
2. PERFORM HOLD-IN COIL OPEN CIRCUIT TEST
Using an ohmmeter, check that there is continuity between
terminal 50 and the switch body.
If there is no continuity, replace the magnetic switch.

ASSEMBLY OF STARTER

(See pageST-15)
HINT: Use.high-temperature grease to lubricate the bear-
ings and gears when assembling the starter.
1.

PLACE ARMATURE INTO FIELD FRAME

Apply grease to the armature bearings, and insert the
armature into the field frame.
2. INSTALL BRUSH HOLDER
(a) Place the brush holder on the armature.
(b) Using a screwdriver, hold the brush spring back, and
connect the brush into the brush holder. Connect the
four brushes.
HINT: Check that positive ( + ) lead wires are not
grounded.