Install Pulley; Install Rectifier Holder - Toyota 1PZ Repair Manual

SST
SST (C)
CHARGING SYSTEM
3.

INSTALL PULLEY

SST
(a) Install the pulley to the rotor shaft by tightening the
(b) Hold SST (A) with a torque wrench, and tighten SST
SST 09820-63010
Torque: 400 kg-cm (29 ft-lb, 39 Nm)
(c) Check that SST (A) is secured to the pulley shaft.
CH0882
(d) As shown in the illustration, mount SST (C) in a vise,
(e) To torque the pulley nut, turn SST (A) in the direction
Torque: 1,125 kg-cm (81 ft-lb, 110 N-m)
(f)
(g) Turn SST (B) and remove SST (A and B).
CH0853 CH0873
4.

INSTALL RECTIFIER HOLDER

(a) (Type A)
CH0854
(b) Install the four rubber insulators on the lead wires.
CH0852
(c) Install the rectifier holder with the four screws.
CH0892
Alternator
pulley nut by hand.
(B) clockwise to the specified torque.
and install the alternator to SST (C).
shown in the illustration.
Remove the alternator from SST (C).
Place the seal plate on the rectifier end frame.
CH-17