Table of Contents
Advertisement
Maintenance and administration terminals
On-site access
Remote access
Chapter 3 — System and site requirements
Refer to "Terminal setup" on page 201 for information about setting up
terminals recommended for use with the Option 11C Mini system.
Under some conditions, you require a Modem Eliminator (NULL Modem
without hardware handshaking) A0601397 F-F converter or A0601396 M-F
to interface the TTY to the system.
The following describes the minimum requirements for a TTY device:
Without Meridian Mail
When the system does not have Meridian Mail installed, and it will not have
Meridian Mail installed in the future, the minimum requirement is a VT100
compatible device.
With Meridian Mail
With Meridian Mail installed, use a VT220 compatible device.
Equip each system with an M2616 or M2008 telephone with display. These
telephones act as maintenance telephones.
You can use many different TTY terminals to access the Option 11C Mini.
However, a VT220 terminal is recommended as an on-site terminal. You can
use this terminal to perform service changes, maintenance and diagnostic
functions, and Meridian Mail administration activities.
Although you can use several types of modems to access the system, a 2400
baud auto-answer modem is the recommended modem. A 1200 baud modem
is the minimum requirement. You can use the modem to perform service
changes, maintenance and diagnostic functions, and Meridian Mail
administration activities from a remote location.
Note: You can perform additional maintenance functions through
remote access on the Option 11C Mini. For additional information, refer
to the Customer Configuration Backup and Restore Guide
(553-3011-330).
Option 11C Mini
Planning and Installation Guide
Page 67 of 332
Hide quick links:
Advertisement
Table of Contents
