Table of Contents
Advertisement
Activating a customized model with a character display
Procedure 37
Activating a customized telephone
1
Plug the telephone set into the jack and wait 20 seconds before
you lift the handset. If you do not receive dial tone, replace the
handset and wait another 10 seconds before going off-hook
again. Repeat this procedure until you receive dial tone.
If successful, the character display shows either "MODEL? X" (if the
telephone relocation feature is not in use) or "RELOC OR MODEL? X"
(if the telephone relocation feature is in use). "X" represents the default
model for the telephone that you are activating.
Note 1: If you do not see the prompt "MODEL X" after lifting the
handset, disconnect the telephone from the wall jack. Wait five seconds
and plug the telephone into the jack again. The telephone now shows
"MODEL X" when you lift the handset.
Note 2: The system requires the 20 second time interval to determine if
the set is new or if it is being relocated using the Modular Telephone
Relocation feature.
2
Enter the digits associated with the customized model and press
the pound key (#).
Dial tone disappears after you press the first digit. You hear special dial
tone after you press the pound key. If you enter a valid model number,
the character display reads "OK, EXTENSION?". If you enter an invalid
model, the previous prompt is reissued and you hear overflow tone.
3
Enter the customized extension number and press the pound
key.
You hear relocation tone. The character display shows "OK".
OR
If the extension number is already in use by another telephone, you
hear special dial tone again. The character display shows
"MULTI-LINE, EXTENSION?".
OR
If the extension number is not available for use, you hear overflow
tone. The character display shows "ERROR, EXTENSION?" and you
must repeat this step.
Chapter 17 — Connecting the telephones
Option 11C Mini
Page 249 of 332
Planning and Installation Guide
Hide quick links:
Advertisement
Table of Contents
