Table of Contents
Advertisement
Page 230 of 332
Cross connecting telephones
553-3021-209
Standard 3.00
Chapter 17 — Connecting the telephones
Refer to the instructions provided with the telephone or Attendant Console
and to the following documents for detailed information about installing
telephones and Attendant Consoles:
•
Meridian 1 Telephone and Attendant Console Installation
(553-3001-215)
•
Meridian 1 European Digital Telephones (553-3001-114)
•
M3900 Series Meridian Digital Telephone Description, Installation, and
Administration (553-3001-216)
Refer to "Appendix A – Preprogrammed data" on page 285 for information
about preprogrammed data.
Before you continue, install the cable from the slot that contains the line card
associated with the telephone being connected. Refer to "Chapter 13 —
Installing and connecting the cross-connect terminal" on page 169, if you
require additional cable installation.
Always use caution when installing or modifying telephone lines. Do
not install telephone wiring during a lightning storm. Do not install
telephone jacks in wet locations unless the jack is designed for wet
locations. Never touch uninsulated telephone wiring unless the line is
disconnected at the network interface.
Connect the telephones according to Figures 65 and 66. Figure 67 on page
233 shows the cross-connect information for the 48-port Digital Line Card.
Procedure 30
Cross connecting telephones
1
Locate the telephone terminations at the cross-connect terminal.
2
Connect the Z-type cross-connect wire to the leads of the
telephone.
3
Locate line circuit card (TN) terminations at the cross-connect
terminal.
April 2000
WARNING
Hide quick links:
Advertisement
Table of Contents
