Conflicts With Call Park Extension Numbers; Conflicts With Sdi Ports; Conflicts With The Spre Code - Meridian Nortel 1 Option 11C Mini Installation Manual

Page 322 of 332

Conflicts with Call Park extension numbers

Conflicts with SDI ports

Conflicts with the SPRE code

553-3021-209 Standard 3.00
Appendix B – Changing preprogrammed data
Extension numbers for system call park are preprogrammed for the Central
Answering Position. To remove this data from the system, load LD 50 and
respond to the prompts as follows:
LD 50
REQ OUT
TYPE CPK
CUST 0
SPDN XXXX "XXXX" = Value of Call Park extension
Repeat for each Call Park extension you want to remove.
Five SDI/ESDI ports are preprogrammed on the Option 11C Mini system.
Ports 8 and 9 are associated with the Meridian Mail Mini. Ports 0, 1 and 2 are
associated with the NTDK97 MSC card. You cannot remove port 0; however,
you can remove any of the remaining ports using LD 17 as follows:
LD 17
REQ CHG
TYPE CFN
ADAN OUT TTY X "X" = the TTY that you are removing.
If the preprogrammed SPRE code conflicts with the programming required
for the Option 11 system, use LD 15 to remove it. For customer 0 enter the
following in response to the SPRE prompt:
LD 15
SPRE Xy "y" = the value of the SPRE code
Note: To define a new SPRE code, type a space and enter the new
number.
April 2000