Installing The Chassis On A Wall In A Vertical Position; Items Required - Meridian Nortel 1 Option 11C Mini Installation Manual

Page 116 of 332

Installing the chassis on a wall in a vertical position

Items required

553-3021-209 Standard 3.00
Chapter 9 — Installing the chassis
An Option 11C Mini chassis is 30 lb. (13.5 kg) with circuit cards
installed. An Option 11C Mini chassis is 26 lb. (12 kg) without circuit
cards installed. Get help lifting the chassis if necessary.
To install the chassis on a wall in a vertical position, you require the following
items:
• equipment layout plan
• chassis bracket
• wall bracket
• five 1 in. #12 wood screws provided in the bracket kit (or other
appropriate fasteners) to hold the wall brackets and chassis on the wall
• four #8 - 32 machine screws, used to attach the chassis brackets to the
wall
• one 3/4 in. (20 mm) piece of plywood fastened to the wall
The NTTK08 bracket kit contains all of the above items, with the exception
of the equipment layout plan and the plywood.
An Option 11C Mini chassis is 30 lb. (13.5 kg) with circuit cards
installed. Make sure that you fasten the equipment securely to the wall.
Use fasteners designed to hold securely to the type of surface that will
support the equipment. When using 3/4 in. (20 mm) plywood, or other
similar material as a backboard, make sure to attach the backboard
directly to the wall studs in a minimum of six locations.
Refer to Figure 22 on page 117 for guidelines on how to position the system
components.
April 2000
WARNING
CAUTION