Table of Contents
Advertisement
Chapter 15 — Installing and connecting SDI and Ethernet ports
Figure 60
An additional ferrite filter attached to the SDI cable
3
Connect the system terminal to the cable marked "port 0" on the
NTBK48 3-port cable.
You require a Modem Eliminator Adapter to connect the Option 11C
Mini to a TTY terminal. This adapter is in included in the NTDK88 cable
kit.
4
If the system is to be accessed remotely, connect the system
modem to the cable marked "port 1" on the NTBK48 cable.
5
Connect the modem to an outside line.
6
Test the modem for correct operation when the system is
operating.
Note: You can use the remaining ports for other equipment, such as
CDR devices or TTYs.
—————————— End of Procedure ——————————
Additional ferrite
filter
Existing ferrite
filter
Option 11C Mini
Page 195 of 332
Planning and Installation Guide
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Nortel Meridian 1 Option 11C Mini and is the answer not in the manual?
Questions and answers