Modifying Model Trunks; Removing Model Trunks; Printing Model Information - Meridian Nortel 1 Option 11C Mini Installation Manual

Page 330 of 332

Modifying model trunks

Removing model trunks

Printing model information

553-3021-209 Standard 3.00
Appendix B – Changing preprogrammed data
If you want to modify a trunk, load LD 14 and enter the following commands
on the TTY:
LD 14
REQ CHG
TYPE aaa M "aaa" = the type of trunk that you are
modifying
MODL YYY "YYY" = the model number of the trunk
that you are modifying (between 1 - 127)
To remove a trunk model from the system, load LD 14 and respond to the
prompts as follows:
LD 14
REQ OUT
TYPE XXX M "XXX" = the trunk type of the model that
you are removing (Examples: COT, TIE,
DID, FEX, WAT, etc.)
CUST 0
MODL YYY "YYY" = the model number associated
with the trunk type you are removing
(Valid range is 1-127).
To print information about model trunks, load LD 20 and enter the following
commands on the TTY:
LD 20
REQ PRT
TYPE TTTT M "TTTT" = the trunk type
MODL YYY "YYY" = the model number. If you want to print all of the
models for this trunk type, leave this value blank.
April 2000