Installing Software In A New System; Summary Of Steps - Meridian Nortel 1 Option 11C Mini Installation Manual

Chapter 16 — Starting the Option 11C Mini and installing software

Installing software in a new system

Summary of steps

Note: Off-site programming of databases is subject to all security
keycode restrictions. The off-site system must either use the Security
Device that will be installed in the Option 11C Mini at the customer site,
or must have its own keycodes for the feature set used.
Remote restored database
A database can be restored remotely using the Overlay 143 CCBR remote
restore command.
Backed up Database
The Backed up Database option allows the copy on the backup flash drive to
be installed. It is provided to recover a customer database if the customer
database on the primary flash drive becomes corrupted.
Before beginning the software installation process, complete Step 1 through
Step 20 in "Summary of installation procedures" on page 92. You must
install the security device on the MSC card, and you must have the Keycode
Data Sheet available.
Note: In the menus and screens, there are references to Option 11 and
Option 11E. These references do not apply to the Option 11C Mini.
The following list summarizes the Software Installation steps:
• Setting the system time and date
• Selecting the New System Installation menu
• Selecting Feature Set and packages
• Selecting a database
• Selecting Incremental Software Management (ISM)
parameters
• Validating keycodes
• Loading the software
Option 11C Mini Planning and Installation Guide
Page 215 of 332