Installing The Chassis On A Wall In A Horizontal Position; Items Required - Meridian Nortel 1 Option 11C Mini Installation Manual

Installing the chassis on a wall in a horizontal position

Items required

To install the chassis on a wall in a horizontal position, you require the
following items:
• equipment layout plan
• one left shelf bracket
• one right shelf bracket
• eight 1 in. #12 wood screws supplied in the bracket kit (or other
appropriate fasteners) to fasten the wall shelf brackets to the wall
• one 3/4 in. (20 mm.) piece of plywood fastened to the wall
The NTTK11 bracket kit contains all of the above items, with the exception
of the equipment layout plan and the plywood.
An Option 11C Mini chassis is 30 lb. (13.5 kg) with circuit cards
installed. Make sure that you fasten the equipment securely to the wall.
Use fasteners, designed to hold securely to the type of surface that will
support the equipment. When using 3/4 in. (20 mm) plywood, or other
similar material as a backboard, make sure you attach it directly to the
wall studs in a minimum of six places.
Refer to Figure 26 on page 122 for guidelines on how to position system
components.
Chapter 9 — Installing the chassis
CAUTION
Option 11C Mini
Page 121 of 332
Planning and Installation Guide