Meridian Nortel 1 Option 11C Mini Installation Manual page 332

Page 332 of 332
553-3021-209 Standard 3.00
Appendix B – Changing preprogrammed data
6 Enter the new access code and press the pound key.
The display shows
"CODE CHANGED".
After a delay of approximately four seconds, you hear special dial tone
and the sequence repeats when the prompt
"ROUTE ACCESS?"
appears.
OR
If the route access code is not available for use, you hear overflow
tone.
The display shows
"USED, ROUTE ACCESS?"
and you must repeat this step.
You must enter a different access code. This sequence continues
until you enter an appropriate new access code.
7 Terminate the sequence by hanging up the telephone.
OR
Repeat the sequence by going through the steps again.
—————————— End of Procedure ——————————
April 2000