Chapter 9 - Installing The Chassis - Meridian Nortel 1 Option 11C Mini Installation Manual

Chapter 9 — Installing the chassis
This chapter describes the four methods you can use to install the Option 11C
Mini chassis. The following procedures describe the four installation
methods:
• Procedure 2: "Installing the Option 11C Mini chassis on a wall in a
vertical position" on page 118
• Procedure 3: "Installing the Option 11C Mini chassis on a wall in a
horizontal position" on page 123
• Procedure 4: "Installing the Option 11C Mini chassis on a table" on
page 128
• Procedure 5: "Installing the Option 11C Mini chassis in a 19 inch
rack/cabinet" on page 131
This chapter also provides guidelines on how to position system components.
See Figures 22, 26, 30, and 32. Also refer to "Chapter 4 — Creating an
equipment layout plan and a card slot assignment plan" on page 69 for
additional information.
If the Option 11C Mini chassis requires earthquake bracing, you must
install the chassis on a wall in a vertical position. Refer to "Earthquake
bracing requirements for chassis installed on a wall in a vertical
position" on page 46 and "Chapter 8 — Bracing the Option 11C Mini
against earthquakes" on page 105.
CAUTION
Option 11C Mini Planning and Installation Guide
Page 115 of 332