Call Button And Indicator Light; Dialing From The Keypad - CyberData 011307 Operation Manual

2.2.1 Call Button and Indicator Light

2.2.1.1 Indicator Light Function
• Upon initial power or reset, the Call Button LED will illuminate.
• During network setup the Call Button LED will blink 10 times per second until the device can find
a network address. This can take from 5 to 60 seconds.
• When the software has finished initialization, the Call Button LED will blink twice.
• When a call is established (not just ringing), the Call Button LED will blink.
• On the
Idle. This option sets the normal state for the indicator light. The indicator light will still blink
during initialization and calls.
• The indicator light flashes briefly at the beginning of RTFM mode.

2.2.2 Dialing from the Keypad

• See the
Parameters".
Operations Guide
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Device Configuration Page, there is an option called
Figure 2-4. Call Button and Indicator Light
Enable Telephone Operation
930935A
Installing the VoIP Indoor Intercom with Keypad
Button and Keypad Lit when
Call button and indicator light
setting in Section 2.4.7, "Configure the Button
8
Intercom Components
CyberData Corporation