Rtfm Button - CyberData 011307 Operation Manual

2.3.6 RTFM Button

When the Intercom is operational and linked to the network, use the Reset Test Function
Management (RTFM) button (see SW1 in
confirm the Intercom's IP Address and test that the audio is working.
Note
2.3.6.1 Announcing the IP Address
To announce a device's current IP address:
1. Press and release the RTFM button (SW1) within a five second window.
Note
Note
2.3.6.2 Restoring the Factory Default Settings
When troubleshooting configuration problems, it is sometimes convenient to restore the device to a
known state.
Note
Operations Guide
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
You must do this test prior to final assembly.
The device will use DHCP to obtain the new IP address (DHCP-assigned address or default
to 10.10.10.10 if a DHCP server is not present).
Pressing and holding the RTFM button for longer than five seconds will restore the device to
the factory default settings.
Each Intercom is delivered with factory set default values.
930935A
Installing the VoIP Indoor Intercom with Keypad
Figure 2-12) on the Intercom board to announce and
Figure 2-12. RTFM Button
17
Intercom Setup
SW1
CyberData Corporation