CyberData 011307 Operation Manual page 55

Note
Web Page Item
Audio Files
0-9
Dot
Audio test
Page tone
Your IP Address is
Rebooting
Restoring Default
Ringback tone
Ring tone
Intrusion Sensor Triggered
Door Ajar
Night Ring
Operations Guide
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Each entry on the Audio Configuration page replaces one of the stock audio files on the
board. When the input box displays the word default, the Intercom is using the stock audio
file. If that file is replaced with a user file, it will display the uploaded filename.
Table 2-16. Audio Configuration Parameters
930935A
Installing the VoIP Indoor Intercom with Keypad
Description
The name of the audio configuration option is the same as
the spoken audio that plays on the board.
'0' corresponds to the spoken word "zero."
'1' corresponds to the spoken word "one."
'2' corresponds to the spoken word "two."
'3' corresponds to the spoken word "three."
'4' corresponds to the spoken word "four."
'5' corresponds to the spoken word "five."
'6' corresponds to the spoken word "six."
'7' corresponds to the spoken word "seven."
'8' corresponds to the spoken word "eight."
'9' corresponds to the spoken word "nine."
Corresponds to the spoken word "dot." (24 character limit)
Corresponds to the message "This is the CyberData IP
speaker test message..." (24 character limit)
Corresponds to a simple tone used for beep on initialization
and beep on page (24 character limit).
Corresponds to the message "Your IP address is..." 
(24 character limit).
Corresponds to the spoken word "Rebooting" 
(24 character limit).
Corresponds to the message "Restoring default" 
(24 character limit).
This is the ringback tone that plays when calling a remote
extension (24 character limit).
This is the tone that plays when set to ring when receiving
a call (24 character limit).
Corresponds to the message "Intrusion sensor triggered."
Corresponds to the message "Door Ajar" 
(24 character limit).
Specifies the ringtone for nightring. By default this
parameter uses the same audio file that is selected for the
Ring Tone parameter.
The Browse button will allow you to navigate to and select
an audio file.
The Play button will play that audio file.
48
Intercom Setup
CyberData Corporation