CyberData 011307 Operation Manual page 33

Web Page Item
Activate Relay During Ring
Activate Relay During Night Ring
Activate Relay While Call Active
Activate Relay on Button Press
Relay on Button Press Timeout (in seconds) Type the desired time (in seconds) that you want the relay
Miscellaneous Settings
Auto-Answer Incoming Calls
Button and Keypad Lit when Idle
Button Brightness (0-255)
Play Ringback Tone
Operations Guide
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Table 2-7. Device Configuration Parameters (continued)
Description
When selected, the relay will be activated for as long as
the call is active.
NOTE: When the phone is set to Auto Answer, it will not
ring and this option does nothing.
Check this box to activate the relay for as long as a Night
Ring tone is ringing.
When selected, the relay will be activated for as long as
the call is active.
When selected, the relay will be activated when the Call
Button is pressed.
to activate after the Call Button is pressed (1 character
limit).
When selected, the device will automatically answer
incoming calls.
When Auto Answer is Off, the device will play a ringtone
through the Intercom speaker until someone presses the
button.
When selected, the Call Button remains lit when idle.
Type the desired button brightness level (0-255).
When selected, you will hear a ringback tone while making
a call.
Click on the Test Audio button to do an audio test. When
the Test Audio button is pressed, you will hear a voice
message for testing the device audio quality and volume.
Click on the Test Microphone button to do a microphone
test. When the Test Microphone button is pressed, the
following occurs:
1. The device will immediately start recording 3 seconds of
audio.
2. The device will beep (indicating the end of recording).
3. The device will play back the recorded audio.
Click on the Test Relay button to do a relay test.
Click on the Start Button Test button to do a button test.
When pressed, the button text will change to Stop Button
Test and in this mode, pressing the button will play test
audio. Also, pressing this button puts the device into a
mode where it will play audio as the buttons are pressed.
For buttons 0 through 9 it will play the audio file for that
number. For buttons *, #, and the Call Button, it will play
the appropriate DTMF tones.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
930935A
Installing the VoIP Indoor Intercom with Keypad
CyberData Corporation
26
Intercom Setup