Quick Start - Avaya 3500 series Getting Started

Getting started fundamentals
starting the switch. Privileged Executive commands are also available in Global and Interface
configuration modes.
Global Configuration mode, also known as config mode, provides commands used to set and
display general switch configurations such as IP address, Simple Network Management
Protocol (SNMP) parameters, Telnet access, and Virtual Local Area Networks (VLAN).
Interface Configuration mode, also known as ifconfig mode, provides commands used to
configure parameters for each port or VLAN such as speed, duplex mode, and rate limiting.
With sufficient permission, you can use the rules in the following table to move between the
command modes.
Command mode and
sample prompt
User Executive
Privileged Executive
3526T#
Global Configuration
3526T<config>#
Interface Configuration
3526T<config-if>#

Quick Start

You can use the install command in Avaya Command Line Interface (ACLI) or the Quick
Start menu in Enterprise Device Manager (EDM) to configure the in-band IP Address and
18 Getting Started
Entrance commands
No entrance command,
3526T>
default mode
enable
From Privileged Executive
mode, enter
configure
From Global Configuration
mode: To configure a port
enter
interface
fastethernet <port
number>
To configure a VLAN enter
interface vlan
<vlan number>
Comments? infodev@avaya.com
Exit commands
exit
or
logout
exit
or
logout
To return to Privileged
Executive mode, enter
end
or
exit
To exit ACLI completely,
enter
logout
To return to Global
Configuration mode, enter
exit
To return to Privileged
Executive mode, enter
end
To exit ACLI completely,
enter
logout
March 2013