Avaya 3500 series Getting Started page 88

Upgrading switch software
Example
The following figure provides a sample output of the download command.
3524GT-PWR+>enable
3524GT-PWR+#download
Address [172.16.3.2] :
Filename [3500_500s_041.img] :
Finished Upgrading Image Rebooting
3524GT-PWR+#
Variable definitions
The following table describes the parameters for the download command.
address <ip>
image <image-name>
image-if-newer <image-name>
diag <filename>
no-reset
poe-module-image
88 Getting Started
to completion (the process can take up to 10 minutes, depending on network
conditions.
When the download process is complete, the switch automatically resets and the
new software image initiates a self-test. The system returns a message after
successfully downloading a new image.
During the download process, the Ethernet Routing Switch 3500 Series is not
operational. You can monitor the progress of the download process by observing
the LED indications.
Variable
Comments? infodev@avaya.com
Value
Specifies the IP address of the TFTP server
you want to use.
Important:
If this parameter is omitted, the system
goes to the server specfied by the
command.
server
Enter the name of the Ethernet Routing
Switch 3500 Series software image you want
to download.
Enter the name of the Ethernet Routing
Switch 3500 Series software image of the
newer version you want to download.
Enter the name of the Ethernet Routing
Switch 3500 Series diagnostic image you
want to download.
Download the specified software without
resetting the unit.
Specifies the name of the PoE image file.
tftp-
March 2013