Configuring the switch using ACLI
Configuring Autosave
The Ethernet Routing Swtich 3500 Series performs a check every 60 seconds to detect
changes to the configuration file or a new log message in the nonvolatile storage. If any of
these events occurs, the switch automatically saves its configuration and the nonvolatile log
to flash memory. Autosave also automatically saves your configuration information following
restarts.
You can enable or disable the Autosave feature. After you disable autosave, changes in the
configuration file are not saved to the flash memory.
Procedure
1. Log on to ACLI in Global Configuration command mode.
2. At the command prompt, enter the following command:
Variable definitions
The following table describes the parameters for the autosave enablecommand.
no
default
Displaying ACLI settings
Display the current ACLI settings such as general console settings, ACLI mode, ACLI user
names and passwords, and password types.
Procedure
1. Log on to ACLI in User EXEC command mode.
2. At the command prompt, enter the following command:
48
Getting Started
[no] [default] autosave enable
Variable
Comments? infodev@avaya.com
Value
Disables the autosave feature.
Returns the autosave feature to the default
value.
DEFAULT: Autosave Enabled
March 2013