Avaya 3500 series Getting Started page 108

Configuring the switch using EDM
Simple Network Time Protocol tab field descriptions
The following table describes the fields on the Simple Network Time Protocol tab.
Name
PrimaryServerAddressType
PrimaryServerAddress
SecondaryServerAddressType
SecondaryServerAddress
State
SyncInterval
ManualSyncRequest
LastSyncTime
LastSyncSourceInetAddressType
108 Getting Started
Description
Specifies the primary SNTP server IP
address type. Values include ipv4 and ipv6.
Specifies the IP address of the primary SNTP
server.
Specifies the secondary SNTP server IP
address type. Values include ipv4 and ipv6.
Specifies the IP address of the secondary
SNTP server.
Specifies if the switch uses SNTP to
synchronize the switch clock to the
Coordinated Universal Time (UTC).
• disabled: the device cannot synchronize
its clock using SNTP
• enabled (unicast): the device
synchronizes to UTC shortly after start time
when network access becomes available,
and periodically thereafter.
Important:
To clear the PrimaryServerAddress and
SecondaryServerAddress, you must first
set the State to disabled.
Specifies the frequency, in hours, that the
device attempts to synchronize with the
SNTP servers. Values range from 0 to 168.
With a value of 0, synchronization occurs
only when the switch boots up..
Specifies that the device will immediately
attempt to synchronize with the SNTP
servers.
Indicates the Coordinated Universal Time
(UTC) when the device last synchronized
with an SNTP server. This is a read-only
value.
Indicates the IP address type of the SNTP
server with which this device last
synchronized. This is a read-only value.
Comments? infodev@avaya.com
March 2013